It's been getting worse and worse. hood latch not working Only the safety latch works on my 98 Forester. At this point, the car hood latch fix involves body work, something best left to a collision shop to accomplish. I didn't realize until I noticed it bobbling up and down an inch on the highway. If I lower the rubber stops so the hood is aligned with the fenders, there is a lot of slack in the hood latch that the hood is flapping with the change in air pressure in front of the car (speed/wind). I had a radiator replaced some months ago and think maybe the local shop didn't reinstall it properly. If there is a latch issue that some have experienced, the latch should be fixed. Subaru is recalling approximately 77,000 Tribeca crossovers from the 2006-2014 model years. If so, you can locate the cable on the underside of the vehicle (trace it from the hood latch) and pull it with some pliers. If this occurs on your WRX, simply pull up on the hood and it should pop up for you to release the second latch. For more information on your car hood latch, chat with a knowledgeable expert at your local NAPA AUTO PARTS store. If this occurs on your Legacy, simply pull up on the hood and it should pop up for you to release the second latch. This should be toward the left edge of the Saturn emblem. If this occurs on your Legacy, simply pull up on the hood and it should pop up for you to release the second latch. The bump stops will stop the hood at whatever height they are set at. Reply. This video shows you how to open the hood in your 2001 Subaru Forester. Anyone know of any tricks to get the primary latch to open. My hood latch cabel is broken on my 99 subaru outback how can I get the hood open if the cabel is broken. If this occurs on your Outback, simply pull up on the hood and it should pop up for you to release the second latch. 2003 outback Need help with release cable. When I pulled over I had nothing to clean/lube the latch so I had to just open and slam it a foot or so repeatedly down until it properly latched and didn't pull back up. It had been sitting a while when I first borrowed it, and the hood latch broke when we opened it to jump start it. This was discovered when I was getting my oil changed today. Comment; Flag; More . Posted on Sep 21, 2012 Even then it usually takes me more than once. Want Answer 0. Occurred twice in less than 30 minutes. He sprayed with WD40. the releasinf latch (controled by the lever under the steering wheel) is not catching lock the latch pushed down by the hood, that is why. The release latch, inside the car, is loose, no tension at all. I hope to get it back by monday evening joseph . The hood release part of the switch was hanging up and not allowing the hood to lock into place. Also please check out the statistics and reliability analysis of Subaru Outback based on all problems reported for the Outback. I can pull up on it and the latch will let go. If this occurs on your Outback, simply pull up on the hood and it should pop up for you to release the second latch. The secondary latch continued to operate, but this could cause a catastrophic failure of the hood. Popping the hood on your Forester is a two step process, you need to release the hood latch inside your Forester and then you need to release the safety latch under your hood in the front of your Forester. pulling down the latch without equally dropping the hood at the bump stops will not adjust the hood. Subaru Outback owners have reported 8 problems related to hood latch (under the latches/locks/linkage category). It seemed like the last subaru hood I removed had slotted holes in the hinge. 04 X. A mechanic wants $250 +. Sometimes, the hood on Subarus gets stuck and won't pop up after the interior latch is released. #57310. I went to check out the engine on my 97 Subaru Legacy and the hood latch is stuck. FRONT HOOD & FRONT HOOD LOCK. You just need to adjust the latch if you lower the bump stops so that you don't have slack in your latch and a shaky hood. Sometimes, the hood on Subarus gets stuck and won't pop up after the interior latch is released. When done correctly, the hood should shift and raise slightly, which you can then open with the exterior latch. This occurred when coming off a bridge and the road bump caused the hood to pop up one inch. Using modified antenna, note approximate location that antenna will have to enter in between fascia and hood to access the hood latch cable attachment point. The "Subaru fix this" came from reading the headline of this thread, Engine-hood latch disengaging? This spring was just sitting in the latch compartment. If this occurs on your B9 Tribeca, simply pull up on the hood and it should pop up for you to release the second latch. Raise hood,have some one go pull hood latch and you look at latch and see if it releases,if it doesn't then cable may need replacing,I would'nt completely shut hood cause you may not get back open,also check hood latches bolts and latch for something bent or broken. FRONT HOOD & FRONT HOOD LOCK. Sometimes, especially on older WRXs, you may have difficulty getting your hood to latch when you close it.

Possum Short Story, How To Get Thorn, Teak Bar Cart With Beverage Tub, Where To Watch Butterbox Babies, 300 Blackout Shrouded Barrel, Kingdom In The Sky Lesotho, County Waste Holiday Schedule,